A device that holds the lamp in position and connects the lamp contacts to the power supply.A lampholder for wet environments and outdoor use, where the performance of the lampholder is not affected by rain and wet weather.

Lamp Holder Price

In the decoration of the house, the lamp holder is essential, in the lamp market ordinary lamp holder as long as 1.5 yuan can be bought in the street, but the highest price reached how much?Take the African small leaf sandalwood floor lamp living room Chinese floor lamp on Taobao to buy 4508 yuan, yes you read it right is 4508.

Lamp Holder Brand

Zhongshan city sharp exhibition lamp head lampholder.The main products are: E14 lampholder. E27 lampholder. E12 lampholder. E26 lampholder. B15 lampholder.Zipper switch lampholder, screw type (knob type) lampholder, push type lampholder, no segment lampholder, two segment lampholder, three segment lampholder.Each etc.

Lamp Holder Installation

Put the installed lamp head hose over the plastic sleeve and insert it into the hole in the clip on the table lamp clamp.Put on the washer and secure the metal hose to the table lamp upper clip firmly with the screw.Strip the insulation from the end of the power cord with wire strippers.Install the power plug.Then red.Black meter stick are connected to the two pins of the power plug.If the resistance is zero, there is an internal short-circuit fault, to immediately verify the elimination.Set the multimeter range switch to the resistance R × 10 gear and adjust the zero.Will be a meter stick and metal hose contact, another meter stick were in contact with the two pins of the power plug, the multimeter pointer should not move.If the pointer is zero or a certain amplitude, it means that there is a short circuit or pathway between the metal hose and the power cord, and there is an unsafe problem.The fault should be carefully verified immediately.

Lamp holder specification

Lampholders are classified according to different installation methods and materials.The installation method is divided into bayonet.Screw-in and inline, etc.The materials of lampholders are metal.Plastic.Bakelite and ceramic, etc.The screw-in lampholder we use in our daily life is E27. The ones starting with E represent screw-in lampholders such as E14, E27, E12, E26 and so on.The bayonet lampholder starts with G, such as G10, and the inline lampholder starts with M, including MR16, MR11, etc. MR16 is a luminaire with a maximum outer diameter of 2 inches and a multi-faceted reflector shade.Bayonet .MR11 is a smaller luminaire than MR16, E14 is a smaller luminaire than E27.

Lampholder Wiring

When we install the lampholder, we should first confirm whether the lampholder we install meets the voltage standard, whether the quality is acceptable, whether there is any damage and so on.The minimum cross-section of the wire of the lampholder should conform to the minimum cross-sectional area stipulated by the state, because if the minimum cross-section of the wire of the lampholder is lower than the minimum cross-sectional area stipulated by the state, it will easily lead to the accident of burning the wire, burning the lampholder, or even fire accident.Therefore, when we wire the lampholder, we must use a wire with a minimum cross-section greater than the national standard to ensure the normal operation of the lampholder in the future.